Hints And Tips For Handling Plumbing Issues

May 2nd, 2013
by Terry Dreary

If plumbing is something that can have you stumped, you probably know how expensive it is to have it done professionally. You also may have to wait for a plumber to arrive when there’s a problem happening now! Don’t let this happen, read on for tips on solving your own plumbing problems!

You always want to solder correctly, the biggest mistake most people make when soldering is failing to get the interior of the fitting and the exterior of the pipe clean and shiny. Polish these surfaces with a fine emery clot until bright. When soldering, never heat the pipe, but instead heat the fitting. Doing so allows the solder to be drawn into the fitting by capillary action.

Use the sounds you hear from your pipes to help you to determine what they problem is. Certain sounds mean the water pressure is too high. Other sounds can signify loose pipes or slight clogs from calcium or iron build up. Listening to your pipes can save you a lot of money hunting down the problem.

To help you repair a leaky water line, you should hire a plumber. A leaky water line can be a problem because it could lead to a flood. The best way to fix this problem is to hire a licensed plumber who is trained to repair the leak.

To prevent the pipes from freezing, it is advisable to seal off air vents, cracks and access doors. In order to keep the heat in and the cold out, you can try using insulation or caulk. In the event a leak occurs, make it a point to remind everyone where the master circuit breaker is so it can be shut off immediately.

Avoid the use of products for your toilet that help with odor, such as bleach tablets. These may deodorize, but they can seriously damage the rubber pieces in the toilet, causing poor functionality or even complete breakdown of the fixture.

You can check your toilet for leaks by adding a few drops of food coloring, Kool Aid or some coffee grounds to the water in the toilet’s tank (not the water in the bowl). Check the water in the bowl after a half hour or so. If any of the coloring agent is visible in the water in the bowl, the tank is leaking, and you will have to have it repaired.

Drain the sediment from the bottom of your hot water heater twice a year to keep the hot water heater working at its optimal levels. Simply open the drain valve and allow the water to run out into a bucket until the water runs clear. Then close the drain valve.

If water backs up from one sink to another, it is because the lines are connected. The part of the branch line for one device might be higher than another, but most likely there is also a blockage in the branch line connecting the two devices as well. This blockage must be cleaned.

As you can see, there’s no reason to pay so much just to wait for a plumber to come and fix a problem that you could be working on yourself. Applying the tips in this article can save you time and money next time your plumbing needs to be repaired.

Posted in Plumbing | Comments (0)

No comments yet

Leave a Reply